Не е така. На многу DVD плеери има видео излез, компонентен излез, VGA, HDMI, оптички и уште не знам што друго. На монитори може да има VGA, RGB, DVI...
Quote from: Zan on 03.11.2013, Sunday, 18:24:11Не е така. На многу DVD плеери има видео излез, компонентен излез, VGA, HDMI, оптички и уште не знам што друго. На монитори може да има VGA, RGB, DVI...Значи вака, да бидам појасен, прашањево ми е, дали е можно на ВГА каблето без никаква електроника, да се наместат пинови, дали ке биде со 3 пина или со 1 пин, на кој жички треба да се залемат пиновите, и дали ке функционира?!
Чаре?!
http://www.ebay.co.uk/bhp/scart-to-vga-adapter
Scart to VGA / ArcadeThis cable lets you connect a DVD player, DTV receiver or any other device with RGB scart output to an Arcade or PC monitor.To use a PC monitor you must enable Progressive scan in your set top box, if your device does not have this capability then you cannot use a PC monitor. On the other hand, for an Arcade monitor you do not need this feature and any box that outputs RGB can be connected.In both cases it is required that your box outputs RGB signals in its Scart socket. Many but not all digital devices do that, and in some cases you must enable RGB output within a settings menu. Note: a VHS VCR or an analogue tuner (satellite / cable / terrestrial) does not offer RGB signals and will not work with this circuit.Electrical schematic:Connection diagram:Connector shown at bottom right is a female stereo audio jack to plug amplified PC speakers.Components surrounded by a dotted line are optional: they generate a vertical sync signal but most monitors do not need it. If your monitor scrolls the picture up or down or does not detect a signal you will have to add these components.Start by setting the 4K7 preset at middle range. If your monitor does not sync properly, does not detect a signal or displays an Out of range message adjust until it works.If your Arcade monitor has a switch or jumper to set sync polarities try all settings until it works. This circuit outputs positive H sync and negative V sync.If it still does not detect a signal or sync properly remove the connection to scart pin 16 and connect that wire to a 5V supply instead, with ground to transistor emitters (E). The scart output may not provide enough voltage or current for proper operation.Note: if you use a standard male-male scart cable and a female socket you must change the following pins: 20 → 19, 6 → 3 and 2 → 1. This is because a male-male cable connects inputs to outputs.
http://www.geocities.ws/podernixie/htpc/cables-en.html